This is a
1.Put the Z-Wave Controller into Inclusion mode.2.Press the On/Off knob 3 times within 1.5 seconds to put the unit into Inclusion mode.
The AN186 On/Off Plug is a Z-Wave Plus enabled device with S2 security function and is fully compatible with any Z-Wave enabled network. The device can be set up in a Z-wave network to communicate directly with other end devices such as PIR motion detector, or to report directly to a Z-wave controller.This On/Off Plug module is designed to control the on/off status of lighting and appliances in the home. Remote On/Off control of the connected load is possible even when paired with other manufacturers Wireless Controller. Each module is also designed to act as a repeater to re-transmit RF signal to ensure that it is received by its intended destination by routing the signal around obstacles and radio dead spots.
Reset to factory default | Please use this procedure only when the network primary controller is missing or otherwise inoperable.1. Press the On/Off knob 3 times within 1.5 seconds to put the unit into exclusion mode.2.Within 1 second of step 1, press and hold the knob for 5 seconds.3.Node ID is deleted. The device reverts to factory default state. |
Inclusion | 1.Put the Z-Wave Controller into Inclusion mode.2.Press the On/Off knob 3 times within 1.5 seconds to put the unit into Inclusion mode. |
Exclusion | 1. Put the Z-Wave Controller into Exclusion mode.2. Press the On/Off knob 3 times within 1.5 seconds to put the unit into Exclusion mode. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 1 | Association with 1node. |
2 | 4 | Association with 4 nodes (i.e. end devices such as detectors or other lighting switches).This allows the On/Off module to receive commands directly from these end devices without the participation of the controller. |
1: remember (0: do not remember) Size: 1 Byte, Default Value: 1
Setting | Description |
---|---|
0 - 1 | 1: remember (0: do not remember) |
Hardware Platform | SD3502 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 1 FW: 1.00:00.05 |
Z-Wave Version | 6.71.01 |
Certification ID | ZC10-17115857 |
Z-Wave Product Id | 0x0060.0x0004.0x000C |
Communications Connections | None |
Electric Load Type | IncandescentLED |
Sensors | Power |
Color | White |
Supported Notification Types | Power Management |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |