Quickstart

This is a secure Door Lock - Keypad for XXXQFrequencyName. To run this device please make sure the internal battery is fully charged. To add this device to your network execute the following action:
Put the Z-Wave controller into add or learn modePress the R button on the lock 3 times quickly (within 1.5 seconds)Refer to the operation manual of the Z-Wave controller to complete the learn in processFor more information on this please visit:www.yale.co.uk/smart-living



Important safety information

Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from Z-Wave Alliance Product data and may be incomplete. Please refer to the Manufacturers Manual for more information.

Product Description

Features:Control Via Smartphone - Configure, Control and unlock your Smart Door Lock from your smartphone via our secure Bluetooth App.Keyless - Say goodbye to keys, Open your Smart Door lock via your smartphone, Key Card or Key Tag.Simple to Fit - Engineered for easy installation.Connectivity - Compatible with the Yale Smart Home system. (Yale module sold separately)Security as standard - Built in tamper alarm, PAS24 accredited.Battery Operated - Powered by 4 AA batteries and a warning when they're running low.Battery Backup - A 9v battery connection port can be used to power the Smart door lock in the event of flat batteries.Secure Push & Turn Thumbturn - Engineered to give additional convenience and security to your door

Reset to factory default Only use this when the existing Z-Wave controller is missing or inoperable Lift up the lever handleWhile holding the handle up, press the R button 3 times within 1.5 seconds
Inclusion Put the Z-Wave controller into add or learn modePress the R button on the lock 3 times quickly (within 1.5 seconds)Refer to the operation manual of the Z-Wave controller to complete the learn in processFor more information on this please visit:www.yale.co.uk/smart-living
Exclusion Put the existing Z-Wave controller into Remove ModePress the R button on the lock 3 times quickly (within 1.5 secs)The lock is now ready to be added to a new Z-Wave controllerFor more information on this please visit:www.yale.co.uk/smart-living
NIF XXXNIF
Wakeup XXXWakeupDescription
Protection XXXProtection
FirmwareUpdate XXXFirmwareUpdate
SetAssociation XXXSetAssociation

Association Groups:

Group Number Maximum Nodes Description
1 1 Z-Wave Plus Lifeline

Configuration Parameters

Parameter 1: Volume

Volume Control (Silent, Low, High)
Size: 1 Byte, Default Value: 3

Setting Description
1 Silent Mode
2 Low Volume Mode
3 High Volume

Parameter 2: Auto Relock

Auto relock will cause the lock to automatically relock if the Conexis has been unlocked, but the lever handle has not been depressed (no-one has walked through the door). On or Off
Size: 1 Byte, Default Value: 0

Setting Description
0 Auto relock off
255 Auto relock on

Parameter 3: Relock Time

The amount of time in seconds before the Conexis auto relocks. This will only happenif the Conexis has been unlocked, but the lever handle has not been depressed (no-one has walked through the door).
Size: 1 Byte, Default Value: 30

Setting Description
7 - 60 Relock time (secs)

Parameter 4: Wrong Tag Limit

The amount if incorrect tags that can be presented to the lock before it times out. Once it has timed out it will stop accepting tags for the amount of time specified in the Wrong Tag timeout
Size: 1 Byte, Default Value: 5

Setting Description
1 - 20 Number of incorrect tags before limit

Parameter 7: Wrong tag timeout

The amount of time the lock will not accept tags for once the wrong tag limit has been reached. It will still be possible to unlock through BLE or the Z-Wave hub.
Size: 1 Byte, Default Value: 180

Setting Description
1 - 250 Timeout time (secs)

Technical Data

Hardware Platform ZM5202
Device Type Door Lock - Keypad
Network Operation Listening Sleeping Slave
Firmware Version HW: 32 FW: 32.16:15.16
Z-Wave Version 6.71.01
Certification ID ZC10-17085747
Z-Wave Product Id 0x0129.0x6600.0x0002
IP (Ingress Protection) Rated ok
Firmware Updatable Updatable by Consumer by RF
Color Chrome
Frequency XXfrequency
Maximum transmission power XXantenna
CEPT (Europe)Door Lock - Keypad