Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
For Inclusion to a network:Put the Z-Wave Interface Controller into Inclusion mode,and followingitsinstructiontoincludeHO-09ZBtoyour controller.This magnetic contact needs to be included beforeinstallation.1.Pull out the insulating strip, making the device power on. 2.Pressing the anti-tamper switch three times.3.Red LED will blink three times while inclusion the network successful 4.If inclusion failed,the sensor will go into sleep mode.To wake thesensor again,you need to use magnet or anti-tamper switch to triggeran inclusion process,and then sensor will repeat steps from 3 to 4.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
This Product apply the theory of magnetic control, when the magnet is separated from the main body from a certain distance (about 2 cm) between ,the main body will send out a wireless alarm signal automatically, in order to prevent someone break into the room from the door or window.
Reset to factory default |
Press the anti-tamper switch five times to reset.Note:Use this procedure only in the event that the primary controller is lost. |
Inclusion |
For Inclusion to a network:Put the Z-Wave Interface Controller into Inclusion mode,and followingitsinstructiontoincludeHO-09ZBtoyour controller.This magnetic contact needs to be included beforeinstallation.1.Pull out the insulating strip, making the device power on. 2.Pressing the anti-tamper switch three times.3.Red LED will blink three times while inclusion the network successful 4.If inclusion failed,the sensor will go into sleep mode.To wake thesensor again,you need to use magnet or anti-tamper switch to triggeran inclusion process,and then sensor will repeat steps from 3 to 4. |
Exclusion |
For Exclusion a network:Put the Z-Wave Interface Controller into Exclusion mode, andfollowing its instruction to exclude magnetic contact from your Z-Wavecontroller.1.Pressing the anti-tamper switch Triple then enter exclusionmode.2.Red LED will blink three times when exclusion of the network is successful. |
NIF |
XXXNIF |
Wakeup |
Press the anti-tamper switch once to wakeup the product. |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 255 FW: 16.08 |
Z-Wave Version |
6.51.09 |
Certification ID |
ZC10-17085742 |
Z-Wave Product Id |
0x0320.0x0001.0x0001 |
Supported Notification Types |
Home Security |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |