This is a
1.Follow the instructions for your Z-Wave certified controller to include the device to the Z-Wave network. 2.Once the controller is ready to include your smart switch, single press and release the manual/program button on the smart dimmer to include it in the network.3.Once your controller has confirmed that the smart switch has been included, refresh the Z-Wave network to optimize performance.
Transform any home into a smart home with the Jasco Z-Wave Smart Lighting Plug-in Smart Switch. The lighting control enables wireless control of on/off functions for standard table and floor lamps, and is compatible with incandescent, LED, Xenon, Halogen, fluorescent and compact fluorescent bulbs. Easily controlled by your mobile device or computer using any Z-Wave certified gateway, the space-saving horizontal module plugs into a standard wall receptacle without blocking the second outlet or obstructing placement of furniture. It provides a Z-Wave enabled outlet for the lamp or appliance that you would like to control. Perfect for plug-in fans, heaters, lamps and more! Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
Reset to factory default | 1.If plugged in, unplug the switch from the receptacle. 2.Press and hold the top button for at least 3 seconds while you plug the switch into a receptacle. Note: this should only be used in the event your networks primary controller is missing or otherwise inoperable. |
Inclusion | 1.Follow the instructions for your Z-Wave certified controller to include the device to the Z-Wave network. 2.Once the controller is ready to include your smart switch, single press and release the manual/program button on the smart dimmer to include it in the network.3.Once your controller has confirmed that the smart switch has been included, refresh the Z-Wave network to optimize performance. |
Exclusion | 1.Follow the instructions for you Z-Wave certified controller to exclude a device from the Z-Wave network. 2.Once the controller is ready to exclude your device, press and release the manual/program button on the smart switch to exclude it from the network. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
2 | 5 | Control group |
3 | 5 | Control group |
LED light off when device is turned off (default) Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
1 | LED light on when device is on |
2 | LED light always on |
Hardware Platform | ZM5202 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 5.23 |
Z-Wave Version | 6.51.10 |
Certification ID | ZC10-17085741 |
Z-Wave Product Id | 0x0063.0x5052.0x3037 |
Firmware Updatable | Updatable by Consumer by RF |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |