This is a
1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.2. Once the controller is ready to include your device, press and release the top or bottom of the smart fan control switch (rocker) to include it in the network.3. Once your controller has confirmed the device has been included, refresh the Z-Wave network to optimize performance.
Transform any home into a smart home with the Jasco Z-Wave Smart Fan Control. The in-wall fan control easily replaces any standard in-wall switch remotely controls a ceiling fan in your home and features a three-speed control system. Your home will be equipped with ultimate flexibility with the Jasco Z-Wave Smart Fan Control, capable of being used by itself or with up to four Jasco add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches and the integrated LED indicator light allows you to easily locate the switch in a dark room. The Jasco Z-Wave Smart Fan Control is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
Reset to factory default | 1. Quickly press ON (Top) button three (3) times then immediately press the OFF (Bottom) button three (3) times. The LED will flash ON/OFF 5 times when completed successfully.Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable. |
Inclusion | 1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.2. Once the controller is ready to include your device, press and release the top or bottom of the smart fan control switch (rocker) to include it in the network.3. Once your controller has confirmed the device has been included, refresh the Z-Wave network to optimize performance. |
Exclusion | 1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network. 2. Once the controller is ready to Exclude your device, press and release the top or bottom of the wireless smart switch (rocker) to exclude it from the network. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline |
2 | 5 | Supports Basic Set and is controlled with the local load |
3 | 5 | Supports Basic Set and is controlled by double pressing the On or Off button |
If the switch is accidentally installed upside down with On at the bottom and Off at the top, thedefault On/Off Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Default |
1 | Invert |
Hardware Platform | ZM5202 |
Device Type | Fan Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 5.22 |
Z-Wave Version | 6.51.10 |
Certification ID | ZC10-17085739 |
Z-Wave Product Id | 0x0063.0x4944.0x3232 |
Neutral Wire Required | ok |
Firmware Updatable | Updatable by Consumer by RF |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |