Quickstart
This is a
Hardware Device for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Unleash the full potential of your TechniSat Smart Home Ready Receiver or Television with TechniSat's Z-Wave Stick 1. Bring "Smart" to your home with the TechniSat devices you already own.TechniSat's Z-Wave Stick 1 enables Z-Wave certified controller software applications supporting the Bridge Controller library to perform Z-Wave network operations - it cannot do Z-Wave network operations on its own.
Reset to factory default |
XXXResetDescription |
Inclusion |
XXXInclusionDescription |
Exclusion |
XXXExclusionDescription |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5101 |
Device Type |
Hardware Device |
Network Operation |
Hardware Device |
Firmware Version |
HW: 0 FW: ERROR |
Z-Wave Version |
6.71.01 |
Certification ID |
ZC10-17065663 |
Communications Connections |
USB (Universal Serial Bus) |
Communications Protocol |
Z-Wave Serial API |
Firmware Updatable |
Updatable by Consumer by Wire |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |