LG Uplus
Open Sensor
SKU: OSLI-01
Quickstart
This is a
1. Press & hold inclusion/Exclusion button during 5 seconds when Open Sensor is exclusion status.2. Press for 5 seconds, LED is turn on.3. Open sensor will try inclusion for 30 seconds when button is released.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Detecting the status of Door or Windows equipped with Z-Wave Open Sensor and notifying the status to a customer via smart phone application.
| Reset to factory default | 1. Press & hold inclusion/Exclusion button during 10 seconds.2. LED will blink while holding the button.3. Factory reset will be done in 10 seconds after releasing button and blink 5 times with 100ms interval. Please use factory reset only when the network primary controller is missing or otherwise inoperable. |
| Inclusion | 1. Press & hold inclusion/Exclusion button during 5 seconds when Open Sensor is exclusion status.2. Press for 5 seconds, LED is turn on.3. Open sensor will try inclusion for 30 seconds when button is released. |
| Exclusion | 1. Receiver will stay exclusion waiting mode.2. Press & hold inclusion/Exclusion button during 5 seconds when Open Sensor is exclusion status.3. Press for 5 seconds, LED is turn on.4. Open sensor will try exclusion when button is released.5. If exclusion is successful, LED will blink 3 times with 250ms interval. |
| NIF | XXXNIF |
| Wakeup | 1. Device sends Wake up Notification by every 15 minutes.2. Devices also sends Wake up Notification when inclusion/exclusion button is shortly pressed regardless of 15minutes interval. |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 1 | Z-Wave Plus Lifeline |
Configuration Parameters
Parameter 1: Battery report Period
Wake Up periodx Configurationvalue = Battery report Period Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 1 - 255 | Default 24 (0x18), 0x01~0xFF in 15 minute increments |
Technical Data
| Hardware Platform | SD3502 |
| Device Type | Notification Sensor |
| Network Operation | Reporting Sleeping Slave |
| Firmware Version | HW: 1 FW: 39.26 |
| Z-Wave Version | 6.61.00 |
| Certification ID | ZC10-17065655 |
| Z-Wave Product Id | 0x0273.0x0003.0x0001 |
| Sensors | Open/Closed (Binary) |
| Supported Notification Types | Home Security |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |