Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Follow the instructions for your Z-Wave certified controller to includea device to the Z-Wave network.2. Once the controller is ready to include your device, press up andrelease the toggle to include it in the network.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The 2 ports smart plug provides one Z-Wave outlet for remote controlled by controller through Z-Wave gateway for internet of thing service and can be configured in Z-Wave sensor network,
| Reset to factory default |
Press and hold the top button for at least 3 seconds while you plug the smart switch into a receptacle.Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
| Inclusion |
1. Follow the instructions for your Z-Wave certified controller to includea device to the Z-Wave network.2. Once the controller is ready to include your device, press up andrelease the toggle to include it in the network. |
| Exclusion |
1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.2. Once the controller is ready to Exclude your device, press up andrelease the toggle to exclude it from the network. |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
2 |
Z-Wave Plus Lifeline |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
On/Off Power Switch |
| Network Operation |
Always On Slave |
| Firmware Version |
HW: 0 FW: 20.15 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-17065636 |
| Z-Wave Product Id |
0x0312.0xB211.0x241C |
| Color |
White |
| Electric Load Type |
FluorescentIncandescentInductive (e.g. Motor)LED |
| Firmware Updatable |
Not Updatable |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
