Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
When the controller is in add mode, press and hold the button for 3 seconds until the RED LED indicator blinks.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
P-M-O is a Power Meter Outlet that can control On / Off remotely.You can completely replace your regular outlet.You can connect home appliances such as home lamps, TVs, and others.The power status can be remotely controlled, and the LED indication changes according to the power status.
Reset to factory default |
Press and hold button for 10 seconds until green and red led indicators blink. P-M-O will be initialized and send a device reset locally notification to the controller. Use this function only if the primary controller is lost or otherwise inoperable. |
Inclusion |
When the controller is in add mode, press and hold the button for 3 seconds until the RED LED indicator blinks. |
Exclusion |
When the controller is in remove mode, press and hold the button for 3 seconds until the RED LED indicator flashes. When the P-M-O unit is disconnected from the Z-Wave network, the RED LED indicator will be toggled every second. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5101 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Firmware Version |
HW: 18 FW: 1.31 |
Z-Wave Version |
6.61.00 |
Certification ID |
ZC10-17025418 |
Z-Wave Product Id |
0x0259.0x0003.0x0002 |
Supported Meter Type |
Electric Energy |
Sensors |
Power |
Color |
White |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |