Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please make sure the internal battery is fully charged.
To add this device to your network execute the following action:
1. When the primary controller is in the adding mode, flick the paddle3 times in the 1.5 second. The primary controller will verify the adding.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The ZWN-BDS is a battery-powered and magnetic contact sensorthat indirectly controls lights and appliances throughout your house.It is fully compatible with other Z-Wave certified device from othermanufacturers and/or other applications. When magnetic contact isbroken, such as a door or window being opened, the ZWN-BDStransmits Open/Close status to the gateway.
Reset to factory default |
4. Flick the program button 3 times in the 1.5 second then press oncenotification tocontroller. Then clear all of information for the network, and restore factory defaults, andresetthe module.Use this procedure only in theevent that the network primary controller is missing or otherwise inoperable. |
Inclusion |
1. When the primary controller is in the adding mode, flick the paddle3 times in the 1.5 second. The primary controller will verify the adding. |
Exclusion |
2. When the primary controller is in the removing mode, flick thepaddle 3 times in the 1.5 second. The primary controller will verifyremoving, remove the module from the current Z-Wave network. |
NIF |
XXXNIF |
Wakeup |
3.ShortpresstheprogrambuttonofZWN-BDS,thatwillsenda wakeupnotification. |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Z-Wave Plus Lifeline1. Battery Report2. Notification Report3. Device Reset Locally Notification |
2 |
5 |
Access Control notifi rep: Notification Report |
3 |
5 |
Home Security notifi rep: Notification Report |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 1 FW: 5.10 |
Z-Wave Version |
6.51.09 |
Certification ID |
ZC10-17015413 |
Z-Wave Product Id |
0x011A.0x0601.0x0903 |
Sensors |
|
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |