This is a
1. Follow the instructions for your Z-Wave certifiedcontroller to include a device to the Z-Wave network.2. Once the controller is ready to add your device,press toggle up and release to include it in the network.
Transform any home into a smart home with the GE Z-Wave In-Wall Smart Toggle Switch. The In-Wall Smart Toggle Switch can easily replaces any standard in-wall switch and remotely controls a light in your home. Your home will be equipped with ultimate flexibility with the Jasco Z-Wave Smart Toggle Switch, capable of being used by itself or with up to four add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches. The GE Z-Wave In-Wall Smart Toggle Switch is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with GE Z-Wave Smart Lighting Controls!
Reset to factory default | 1. Quickly press ON (up) button three (3) times thenimmediately press the OFF (down) button three(3) times. Note: This should only be used in the event yournetworks primary controller is missing or otherwiseinoperable. |
Inclusion | 1. Follow the instructions for your Z-Wave certifiedcontroller to include a device to the Z-Wave network.2. Once the controller is ready to add your device,press toggle up and release to include it in the network. |
Exclusion | 1. Follow the instructions for your Z-Wave certifiedcontroller to remove a device from the Z-Wave network.2. Once the controller is ready to remove your device,press toggle up or down to exclude it from the network. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline, Binary Switch Report. |
2 | 5 | Supports Basic Set and is controlled with the local load. |
3 | 5 | Supports Basic Set and is controlled by pressing the On or Off button. |
Invert Switch Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Default |
1 | Invert Switch |
Hardware Platform | ZM5202 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 5.20 |
Z-Wave Version | 6.51.06 |
Certification ID | ZC10-16115300 |
Z-Wave Product Id | 0x0063.0x4952.0x3038 |
Neutral Wire Required | ok |
Firmware Updatable | Updatable by Consumer by RF |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |