This is a
1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.2. Once the controller is ready to include your device, press up and release the Toggle Switch to add it in the network.3. Once your controller has confirmed that the device has been included.
Transform any home into a smart home with the Jasco Z-Wave Smart Toggle Switch. The In-Wall Smart Toggle Switch can easily replaces any standard in-wall switch and remotely controls a light in your home. Your home will be equipped with ultimate flexibility with the Jasco Z-Wave Smart Toggle Switch, capable of being used by itself or with up to four add-on switches. Screw terminal installation provides improved space efficiency when replacing existing switches. The Jasco Z-Wave In-Wall Smart Toggle Switch is compatible with any Z-Wave certified gateway, providing access to many popular home automation systems. Take control of your home lighting with Jasco Z-Wave Smart Lighting Controls!
Reset to factory default | 1. Quickly press ON (up) three (3) times then immediately press the OFF (down) button three (3) times. Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable. |
Inclusion | 1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.2. Once the controller is ready to include your device, press up and release the Toggle Switch to add it in the network.3. Once your controller has confirmed that the device has been included. |
Exclusion | 1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.2. Once the controller is ready to Exclude your device, press and release the top or bottom of the wireless smart dimmer (rocker) to exclude it from the network. |
NIF | XXXNIF |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Z-Wave Plus Lifeline, Binary Switch Report. |
2 | 5 | Supports Basic Set and is controlled with the local load. |
3 | 5 | Supports Basic Set and is controlled by pressing the on or off button. |
Invert Switch Size: 1 Byte, Default Value: 0
Setting | Description |
---|---|
0 | Defualt |
1 | Invert Switch |
Hardware Platform | ZM5202 |
Device Type | On/Off Power Switch |
Network Operation | Always On Slave |
Firmware Version | HW: 255 FW: 5.20 |
Z-Wave Version | 6.51.06 |
Certification ID | ZC10-16115299 |
Z-Wave Product Id | 0x0063.0x4952.0x3132 |
Firmware Updatable | Updatable by Consumer by RF |
Neutral Wire Required | ok |
Frequency | XXfrequency |
Maximum transmission power | XXantenna |