Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.2. Once the controller is ready to include your device, triple click Tamper switch to include it in the network.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The Motion Sensor is designed to be used indoor or outdoor. When mounted properly it can monitor large or open areas such as entrances, living rooms, family rooms, driveways, backyards, walkways, workshops..etc. When the Sensor detects motion, it will transmit a signal to the controller.
Reset to factory default |
Press and hold Tamper switch for at least 3 seconds while you insert the battery.*Use this procedure only in the event that the network primary controller is missing or otherwise inoperable |
Inclusion |
1. Follow the instructions for your Z-Wave certified controller to include a device to the Z-Wave network.2. Once the controller is ready to include your device, triple click Tamper switch to include it in the network. |
Exclusion |
1. Follow the instructions for your Z-Wave certified controller to exclude a device from the Z-Wave network.2. Once the controller is ready to Exclude your device, triple click Tamper switch to exclude it from the network. |
NIF |
XXXNIF |
Wakeup |
The sensor was wake up when temper switch on or get triggered signal after mounted on site. |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Notification Sensor |
Network Operation |
Reporting Sleeping Slave |
Firmware Version |
HW: 1 FW: 20.15 |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-16105259 |
Z-Wave Product Id |
0x015D.0x2003.0x701C |
Color |
White |
Sensors |
Motion/No Motion (Binary) |
Switch Type |
Toggle |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |