Quickstart
This is a
Door Lock Keypad for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Press [SET] for 1 second2. Enter 4-8 digitsPrograming Code3. Press the buttons #90#4. Include successfully (beep * 1)
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Great ConvenienceTouch to activate, touch to lockConnect your Z-Wave smart home system and operate from anywhereHolds up to 25 user codesHolds up to 4 single-entry codesVacation mode (deactivates all user codes temporarily)Auto-lock with adjustable delay (10 - 99 seconds)Back-up mechanical keywayUncompromised SecurityANSI Grade 2 qualitydeadbolt operates over 150,000 timesANSI A156.25 compliant - resistant to dust, rain, and corrosion under variable temperatures4-digit random guiding code prevents code-probingTouch screen is temporarily disabled after 4 consecutive incorrect entriesEasy InstallationEasy installation with a Philips screwdriverFits most standard door preparationsOnline video instruction available (please scan the QR code on this box)
Reset to factory default |
1. Remove one battery.2. Press and hold SET button while inserting the battery back. Hold the set button until long beep has finished.3. Resotring the lock to factory settings will remove its connection to your network and clear all devices from its assocation group. The reset procedure should only be used when the primary controller is missing or inoperable.4. Please re-enter the default Programming Code to set up the lock after restoring to factory settings. |
Inclusion |
1. Press [SET] for 1 second2. Enter 4-8 digitsPrograming Code3. Press the buttons #90#4. Include successfully (beep * 1) |
Exclusion |
1. Press [SET] for 1 second2. Enter 4-8 digitsPrograming Code3. Press the buttons #90#4. Exclude successfully (beep * 1) |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline; A NOTIFICATION frame is sent to the nodes in this association group when a lifeline event occurs. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Door Lock Keypad |
Network Operation |
Listening Sleeping Slave |
Firmware Version |
255.1.66.1.1 |
Z-Wave Version |
6.51.07 |
Certification ID |
ZC10-16095240 |
Z-Wave Product Id |
0x0X26.0x0X03.0X0001 |
Door Lock Type |
|
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |