Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Have Z-Wave controller with inclusion mode2. Press the socket on/off button three times within 1.5 seconds to be included to the controller
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
1. This plug-in ON/OFF switch in a transceiver which is a Z-Wave enabled device and is fully compatible with any Z-Wave enabled network. 2. Each socket is designed to act as a repeater. Repeaters will re-transmit the RF signal to ensure the signal to ensure that the signal is received by its intendeddestination.3. You can use the button in the socket to include/exclude, manually on/off or act as a indicator. You can use it to turn on/off appliance remotely via smart home or computer.
Reset to factory default |
1. Press the socket on/off button three times within 1.5 seconds2.then within 1 second to press and hold on for 5 seconds until the socket button LED is off, reset to factory default successfully3. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable |
Inclusion |
1. Have Z-Wave controller with inclusion mode2. Press the socket on/off button three times within 1.5 seconds to be included to the controller |
Exclusion |
1. Have Z-Wave controller with exclusion mode2. Press the socket on/off button three times within 1.5 seconds to be excluded from the controller |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Firmware Version |
HW: 1 FW: 2.00 |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-16095206 |
Z-Wave Product Id |
0x0118.0x0003.0x0002 |
Color |
White |
Switch Type |
Push Button |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |