Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
STEP 1: Ensure the LED is flashing RED on the SSR 302, if not follow the Exclusion steps first.STEP 2: Put the 3rd party controller into inclusion mode.STEP 3: Press and hold both white buttons on the SSR 302 until the LED starts flashing green.The SSR 302 has been added onto the network and the LED will go solid amber.NOTE: If the LED does not go solid amber then the add process has been unsuccessful.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
The SSR 302 is a 2-channel relay/switch, it forms part of central heating and hot water control system, it can be operated by any third party controllers/Thermostat using Binary Switch CC commands.SSR 302 will act as a repeater once added into the Z-Wave network, providing an alternative communication route for units which otherwise would not be within communication distance of each other.SSR 302 has a fail-safe mode where by the relay is turned OFF if another 'Thermostat Mode SET' command has not been received within 60 minutes.
Reset to factory default |
"Please use this procedure only when the primary controller is missing or otherwise inoperable."Follow Exclusion steps. |
Inclusion |
STEP 1: Ensure the LED is flashing RED on the SSR 302, if not follow the Exclusion steps first.STEP 2: Put the 3rd party controller into inclusion mode.STEP 3: Press and hold both white buttons on the SSR 302 until the LED starts flashing green.The SSR 302 has been added onto the network and the LED will go solid amber.NOTE: If the LED does not go solid amber then the add process has been unsuccessful. |
Exclusion |
STEP 1: Put the 3rd party controller into exclusion mode.STEP 2: Press and hold the two white buttons on the SSR 302.The SSR 302 has been removed from the network when the LED starts flashing red.NOTE: If the LED does not flash red then the remove process has been unsuccessful. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
4 |
Z-Wave Plus Lifeline,SSR 302 will send unsolicited 'Binary Switch Report'to lifeline group whenever its relay status change. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Firmware Version |
HW: 1 FW: 2.1 |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-16075133 |
Z-Wave Product Id |
0x0059.0x0003.0x0006 |
Electric Load Type |
Inductive (e.g. Motor) |
Neutral Wire Required |
ok |
Color |
White |
Loads Controlled |
2 |
IP (Ingress Protection) Rated |
ok |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |