Ei Electronics
Z-Wave CO Detector
SKU: EiA200ZW
Quickstart
This is a
Pressing the button 'Inclusion Button' for one second will include the device. If the button is pressed for at least 2 seconds the inclusion will be done without the Security Command Class.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
The High-End Electro-Chemical Carbon Monoxide alarm head offers a 10 year sensor life and is powered via a 3V lithium battery that powers the Alarm head for the life of the alarm. The CO Sensor is monitored electronically and will report the following:
1. Alarm on Sensing Carbon Monoxide
2. Battery status reporting
3. Sensor Fault
4. Alarm removal from mounting plate
5. End of life to make sure it is replaced on time.
The device is a secure Z-Wave Plus device and can be used in one wireless Z-Wave network with other certified devices regardless of origin and brand.
| Reset to factory default | To do a factory reset press the button on the bottom of the device for at least 10 seconds. This procedure should only be used when the primary controller is inoperable. |
| Inclusion | Pressing the button 'Inclusion Button' for one second will include the device. If the button is pressed for at least 2 seconds the inclusion will be done without the Security Command Class. |
| Exclusion | A single click on the button will exclude the device. |
| NIF | XXXNIF |
| Wakeup | A single click on the button will wakeup the device. |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 10 | Z-Wave Plus Lifeline |
| 2 | 10 | Switching Command when Alarm |
Configuration Parameters
Parameter 1: Value of On-Command
Size: 1 Byte, Default Value: 99
| Setting | Description |
|---|---|
| 0 - 99 | value |
Parameter 2: Value of Off-Command
Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 - 99 | value |
Technical Data
| Hardware Platform | ZM5202 |
| Device Type | Notification Sensor |
| Network Operation | Reporting Sleeping Slave |
| Firmware Version | 1.1.0 |
| Z-Wave Version | 6.51.06 |
| Certification ID | ZC10-16065103 |
| Z-Wave Product Id | 0x026B.0x0004.0x0003 |
| Color | |
| Sensors | |
| Frequency | XXfrequency |
| Maximum transmission power | XXantenna |