Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
When the controller is in add mode, and once program button is pressed and released, or Flick 3 times of the connected switch in 1.5S, willalsosettheZWN-RSM1 module enter into learn mode and then the controller will verify the add.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Z-Wave unifies all your home electronics into an integrated wireless network and helps them talk to each other. It can be added to the network,and making your home electronics fully compatible. The ZWN-RSM1 Switch Module is a component of lighting control system, it cant be used separately but should turn an existing switch into a Z-Wave switch. This ZWN-RSM1 module is a Z-Wave enabled device and fully interoperable with other Z-Wave certified device from other manufacturers and/or other applications. In a Z-Wave network, each device is designed to act as a wireless repeater. Once the ZWN-RSM1 module is installed and setup with in your wall, it will retransmit the RF signal from one device to another until the intended device is reached. This ensures that the signal is received by its intended destination by routing the signalaround obstacles and radio dead spots.
Reset to factory default |
Once program button is pressed and hold for 10 second, the device will send a device reset locally notification to controller. Then clear all of information for the network, and restore factory defaults, and reset the module. Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
Inclusion |
When the controller is in add mode, and once program button is pressed and released, or Flick 3 times of the connected switch in 1.5S, willalsosettheZWN-RSM1 module enter into learn mode and then the controller will verify the add. |
Exclusion |
When the controller is in remove mode, and once program button is pressed and released, or Flick 3 times of the connected switch in 1.5S, will also set theZWN-RSM1 module enter into learn mode and then the controller will verify the remove. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
1 |
Lifeline: Send device reset locally notification |
2 |
5 |
StatusReport: Send basic report |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Firmware Version |
HW: 1 FW: 5.10 |
Z-Wave Version |
6.51.07 |
Certification ID |
ZC10-16055064 |
Z-Wave Product Id |
0x011A.0x0111.0x0605 |
Switch Type |
Toggle |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |