Quickstart
This is a
Valve - Open/Close for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Plug the valve control in within 3 feet from your controller.2. Put your Z-Wave controller in inclusion mode.3. Press the red power button on the valve control THREE times quickly.4. A new on-off device should appear on your controller's dashboard.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Once the Z-Wave valve control is added to your network, you are able to close and open the valve from your mobile device or a computer. Depending on your Z-Wave gateway's home automation software you may be able to associate Z-Wave valve control device in groups with other Z-Wave devices to schedule scenes or create events. Example: if a water sensor detects water your gateway will send a signal to shut the water valve off. Or, you'll be able to turn your vacation home water valve on or off remotely.- Indoor installation only!- Adjustable bracket fits all standard ball valves.- Compatible with standard Z-Wave home automation systems supporting binary switch command.- Z-Wave Plus with improved 500 chip for faster and safer wireless communication. - Built-in Z-Wave signal repeater.
Reset to factory default |
If your primary controller is missing or inoperable, you may need to reset the device to factory settings. To complete the reset process manually, please press and hold the red power button for 10 seconds. The LED indicator on the device will flash to indicate the process has been successfully completed.NOTE: All previously recorded activity and custom settings will be erased from the devices memory. |
Inclusion |
1. Plug the valve control in within 3 feet from your controller.2. Put your Z-Wave controller in inclusion mode.3. Press the red power button on the valve control THREE times quickly.4. A new on-off device should appear on your controller's dashboard. |
Exclusion |
1. Plug the valve control in within 3 feet from your controller.2. Put your Z-Wave controller in exclusion mode.3. Press the red power button on the valve control THREE times quickly.4. The device should disappear from your controller's dashboard. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Valve - Open/Close |
Network Operation |
Always On Slave |
Firmware Version |
HW: 2 FW: 0.02 |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-16045045 |
Z-Wave Product Id |
0x027A.0x0003.0x0512 |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |