Quickstart
This is a
Notification Sensor for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Bring the motion sensor within 3 feet from your controller.2. Put your Z-Wave controller in inclusion mode.3. Press and release the Z-Wave button on the motion sensor TWICE quickly (to lock and unlock it).4. A new motion detection device should appear on your controller's dashboard.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Use this sleek and efficient motion sensor in your DIY security system or for added convenience. Trigger Z-Wave light switches when motion is detected. Receive notifications of unexpected activity while you are away.Install and add the sensor to your Z-Wave controller in minutes. Enjoy Z-Wave Plus for faster and safer wireless communication. Choose from 2 powers sources: standard AAA batteries or micro USB power adapter.Detection Radius: 110 / 16-23 feet Power: DC 5V/1A or 4 AAA (1.2V) batteries Power Consumption: < 15mA when idle / < 38mA when active Range: Up to 100 feet line of sight Operating Temperature: 14 F to 122 F Operating Humidity:80% Installation and Use: Indoor only
| Reset to factory default |
If your primary controller is missing or inoperable, you may need to reset the device to factory settings. To complete the reset process manually, please press the Z-Wave SIX TIMES quickly (3 lock-unlock cycles).NOTE: All previously recorded activity and custom settings will be erased from the devices memory. |
| Inclusion |
1. Bring the motion sensor within 3 feet from your controller.2. Put your Z-Wave controller in inclusion mode.3. Press and release the Z-Wave button on the motion sensor TWICE quickly (to lock and unlock it).4. A new motion detection device should appear on your controller's dashboard. |
| Exclusion |
1. Bring the motion sensor within 3 feet from your controller.2. Put your Z-Wave controller in exclusion mode.3. Press and release the Z-Wave button on the motion sensor TWICE quickly (to lock and unlock it).4. The device should disappear from your controller's dashboard. |
| NIF |
XXXNIF |
| Wakeup |
Press and release the Z-Wave button on the motion sensor TWICE quickly (to lock and unlock it) to wake the device up for 10 seconds. |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Notification Sensor |
| Network Operation |
Reporting Sleeping Slave |
| Firmware Version |
HW: 1 FW: 0.01 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-16045043 |
| Z-Wave Product Id |
0x027A.0x0500.0x0003 |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
