Quickstart
This is a
Siren for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
Inclusion(Add):Please press the Z-Wave button when the Z- Wave controller sends the instructions for inclusion, Press the Button 3 times it will send the NIF
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
This Siren takes DC 5V usb power, and supports 4xAAA backup battery in case of possible power off.
Reset to factory default |
Press and hold the button 10 seconds . The device will send the reset notification to the list node in the group1 and erases the device memory.Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable. |
Inclusion |
Inclusion(Add):Please press the Z-Wave button when the Z- Wave controller sends the instructions for inclusion, Press the Button 3 times it will send the NIF |
Exclusion |
Exclusion(Remove):Please press the Z-Wave button when the Z-Wave controller sends the instructions for exclusion, Press the Button: 3 times it will send the NIF |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus LifelineIf setting the association this siren may send the Switch_Binary_report to the node. |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
Siren |
Network Operation |
Always On Slave |
Firmware Version |
HW: 2 FW: 0.02 |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-16035026 |
Z-Wave Product Id |
0x0152.0x0003.0x0003 |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |