Quickstart
This is a
Light Dimmer Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
You can add the device by either hardware button.-hardware button : Press the Add/Remove button.(1Second)1. Click an [Add] icon in Z-Wave PC Controller Program2. Press the hardware button in a Kumho light lamp for 1 second3. The device will be added to the Z-Wave network
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Use eco-friendly LED lighting that can replace conventional lighting for energy Saving.After install household lighting in a room. you can control of turn on/off LED lighting from inside and outside, also control brightness and color temperature of lamp for variety of moods.Use extra Gateway for control operation the above function.
Reset to factory default |
"Use this procedure only when the network primary controller is missing or otherwise inoperable."1. Press the hardware button in a Kumho light lamp for 10 seconds2. Device Reset Locally notification will be sent |
Inclusion |
You can add the device by either hardware button.-hardware button : Press the Add/Remove button.(1Second)1. Click an [Add] icon in Z-Wave PC Controller Program2. Press the hardware button in a Kumho light lamp for 1 second3. The device will be added to the Z-Wave network |
Exclusion |
You can remove the devicee by either hardware button.-hardware button : Press the Add/Remove button.(1Second)1. Click a [Remove] icon in Z-Wave PC Controller Program2. Press the hardware button in a Kumho light lamp for 1 second3. The device will be removed from the Z-Wave network |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
WML-C85 |
Device Type |
Light Dimmer Switch |
Network Operation |
Always On Slave |
Firmware Version |
FF |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-16010001 |
Z-Wave Product Id |
0x023A.0x0001.0x0001 |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |