Quickstart
This is a
On/Off Power Switch for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Enter the application in the smart phone.2. Touch the" Add New Device" in the screen of the smart phone.3. Select"Switch".4. Press the top button gently on the switch for 3(three) seconds and then the status led will start to flash.5. Then stop pressing the top button.6. Then the status led will be turned off.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
BANDI's switch, GOLI, doesn't require any neutral line; the switch uses the existing in-wall switch power line.The switch boosts power which is consumed by lamp. GOLI is applicable both for existing and new houses and buildings.
Reset to factory default |
1. Press the top button on the switch for 10(ten) seconds.2. Then the status led will be turned on.*Use this procedure only in the event that the network primary controller is missing or otherwise inoperable. |
Inclusion |
1. Enter the application in the smart phone.2. Touch the" Add New Device" in the screen of the smart phone.3. Select"Switch".4. Press the top button gently on the switch for 3(three) seconds and then the status led will start to flash.5. Then stop pressing the top button.6. Then the status led will be turned off. |
Exclusion |
1. Enter the application in the smart phone.2. Touch the" Remove New Device" in the screen of the smart phone.3. Select"Switch".4. Press the top button gently on the switch for 3(three) seconds and then the status led will start to flash.5. Then stop pressing the top button.6. Then the status led will be turned on. |
NIF |
XXXNIF |
Wakeup |
XXXWakeupDescription |
Protection |
XXXProtection |
FirmwareUpdate |
XXXFirmwareUpdate |
SetAssociation |
XXXSetAssociation |
Association Groups:
Group Number |
Maximum Nodes |
Description |
1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
Hardware Platform |
ZM5202 |
Device Type |
On/Off Power Switch |
Network Operation |
Always On Slave |
Firmware Version |
01 |
Z-Wave Version |
6.51.06 |
Certification ID |
ZC10-15120004 |
Z-Wave Product Id |
0x0236.0x0003.0x0002 |
Frequency |
XXfrequency |
Maximum transmission power |
XXantenna |