Quickstart
This is a
Valve - Open/Close for XXXQFrequencyName.
To run this device please connect it to your mains power supply.
To add this device to your network execute the following action:
1. Follow the instructions for your Z-wave certified controller to include a device to the Z-wave network.2.Once the controller is ready to include your device, press the red button 3 times to include it in the Z-wave network.
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law.
The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material.
Use this equipment only for its intended purpose. Follow the disposal instructions.
Do not dispose of electronic equipment or batteries in a fire or near open heat sources.
Attention: This manual is automatically generated from
Z-Wave Alliance Product
data and may be incomplete. Please refer to the
Manufacturers Manual for more information.
Product Description
Automatic Water shut off controller, fits over standard 1/2, 3/4 and 1 ball valves, no plumbing required, 12V DC power, Blue LED status indicator, 500 Series Z-Wave. Includes mounting kit and and AC Adapter and quick start guide, Z-Wave and FCC certified. Prevents water damage when combined with standard smart home automation solutions.
| Reset to factory default |
Press and hold the button 10 seconds and release the button. The device will send the reset notification to the list node in the group1 and erases the device memory , when the light flash it is resetting success.Note: This should only be used in the event your networks primary controller is missing or otherwise inoperable. |
| Inclusion |
1. Follow the instructions for your Z-wave certified controller to include a device to the Z-wave network.2.Once the controller is ready to include your device, press the red button 3 times to include it in the Z-wave network. |
| Exclusion |
1. Follow the instructions for your Z-wave certified controller to exclude a device to the Z-wave network.2.Once the controller is ready to exclude your device, press the red button 3 times to exclude it from the Z-wave network. |
| NIF |
XXXNIF |
| Wakeup |
XXXWakeupDescription |
| Protection |
XXXProtection |
| FirmwareUpdate |
XXXFirmwareUpdate |
| SetAssociation |
XXXSetAssociation |
Association Groups:
| Group Number |
Maximum Nodes |
Description |
| 1 |
5 |
Z-Wave Plus Lifeline |
Technical Data
| Hardware Platform |
ZM5202 |
| Device Type |
Valve - Open/Close |
| Network Operation |
Always On Slave |
| Firmware Version |
02 |
| Z-Wave Version |
6.51.06 |
| Certification ID |
ZC10-15100018 |
| Z-Wave Product Id |
0x0152.0x0003.0x0512 |
| Frequency |
XXfrequency |
| Maximum transmission power |
XXantenna |
