Aeotec
Z-Stick Gen5
SKU: AEOEZW090PLUS-C
Quickstart
This is a
Important safety information
Please read this manual carefully. Failure to follow the recommendations in this manual may be dangerous or may violate the law. The manufacturer, importer, distributor and seller shall not be liable for any loss or damage resulting from failure to comply with the instructions in this manual or any other material. Use this equipment only for its intended purpose. Follow the disposal instructions. Do not dispose of electronic equipment or batteries in a fire or near open heat sources.Product Description
Aeotec Z-Stick Gen5 is a USB controller. When connected to a host controller via USB, it enables the host controller to take part in the Z-Wave network.Products that are Z-Wave certified can be used and communicate with other Z-Wave certified devices.
| Reset to factory default | Use this procedure only in the event that the primary controller is missing or otherwise inoperable.Press and hold the Action Button on Z-Stick for 20 seconds and then release. |
| Inclusion | Plug the Z-Stick into USB port of your host Controller and then click the Inclusion button on yourPC/host Controller application. |
| Exclusion | Plug the Z-Stick into USB port of your host Controller and then click the Exclusion button on yourPC/host Controller application. |
| NIF | XXXNIF |
| Wakeup | N/A |
| Protection | XXXProtection |
| FirmwareUpdate | XXXFirmwareUpdate |
| SetAssociation | XXXSetAssociation |
Association Groups:
| Group Number | Maximum Nodes | Description |
|---|---|---|
| 1 | 5 | Z-Wave Plus Lifeline |
Configuration Parameters
Parameter 220: Configure the RF power level
This parameter is used to configure the RF power level.Note: There are 10 levels can be configured for the RF power level.Value=1, which is the minimum level.value =10, which is the maximum level. Size: 1 Byte, Default Value: 10
| Setting | Description |
|---|---|
| 1 - 10 | There are 10 levels can be configured for the RF power level |
Parameter 242: Enable/disable Security network
This parameter is used to enable/disable security network. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Disable |
| 1 | Enable. |
Parameter 252: Enable/disable the configuration parameters to be locked.
This parameter is used to Enable/disable the configuration parameters to be locked.(0== disable, 1== enable). Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 0 | Disable. |
| 1 | Enable. |
Parameter 255: Reset the configuration parameter to default factory setting
This parameter is used to reset all configuration parameter to default factory setting. Size: 1 Byte, Default Value: 0
| Setting | Description |
|---|---|
| 1 | Resets all configuration parameters to default setting. |
Parameter 81: Enable/disable the LED indicator
This parameter is used to enable/disable the LED indicator. Size: 1 Byte, Default Value: 1
| Setting | Description |
|---|---|
| 1 | Enable. |
| 0 | Disable. |
Technical Data
| Dimensions | 89 x 29 x 11 mm |
| Weight | 15 gr |
| Hardware Platform | ZM5101 |
| EAN | 1220000016774 |
| Device Type | Central Controller |
| Network Operation | Central Static Controller |
| Z-Wave Version | 6.51.06 |
| Certification ID | ZC10-15060008 |
| Z-Wave Product Id | 0x086.0x0001.0x005A |
| Frequency | Europe - 868,4 Mhz |
| Maximum transmission power | 5 mW |