This is a
A single Click on the Z-Wave Button on the bottom side to confirm inclusion, exclusion and association.
The concentration of CO2 in the air is measured in parts per million (ppm). The CO2 concentration outdoors is approx. 350 ppm on average. A level of above approx. 800 ppm negatively impacts on our well-being. The concentration of CO2 in a room depends on the number of people in the room, the length of time that they spend in that room and the air exchange rate. For example, a 60 m2 room that contains two people and has an air exchange rate of 1 will reach a CO2 concentration of 900 ppm. Without ventilation, the concentration of CO2 in the room would increase to 1,500 ppm after two hours and 2,500 ppm after five hours. In order to measure air quality, SENSOAIR type wave uses two sensors to detect the carbon dioxide (CO2) concentration in closed rooms. The quality of the air that has been measured is indicated using a LED light and is transmitted via Z-Wave.
Note:
Before putting the system into service an automatic calibration has to be done.
Preconditions: The room has to be well ventilated. The room temperatur should be between 5C and 40C. There must be no persons or animals in the area of operation.
Calibration:
The SENSOAIR measures the carbon dioxide concentration (CO2) of the ambient air. The measured air qualitiy is shown with the LED lights.
Reset to factory default | Push and hold the Z-Wave Button on the bottom side for 5 seconds to reset the device to factory settings. |
Inclusion | Single Click the Z-Wave Button on the bottom side confirms inclusion and exclusion. |
Exclusion | Single Click the Z-Wave Button on the bottom side confirms inclusion and exclusion. |
NIF | Single Click the Z-Wave Button on the bottom side |
Wakeup | XXXWakeupDescription |
Protection | XXXProtection |
FirmwareUpdate | XXXFirmwareUpdate |
SetAssociation | XXXSetAssociation |
Group Number | Maximum Nodes | Description |
---|---|---|
1 | 5 | Unsolicitated Sensor Reports |
Contains bits for device settings. Size: 1 Byte, Default Value: 8d
Setting | Description |
---|---|
Byte 1: 00000001 | Send unsolicitated reports when the C02 level hits 600, 800, 100, 1500, 2000 or 2500 ppm. |
Byte 1: 00000010 | Enables regular unsolicited Sensor reports. |
Byte 1: 00000100 | A BASIC Set command is send, when the sensor hits the defined CO2 level. |
Byte 1: 00001000 | Enables broadcast reports. |
Byte 1: 10000000 | Enables the front side LED. |
The parameter defines how often a Sensor report shall be sent when enabled by parameter 1 Size: 2 Byte, Default Value: 001e
Setting | Description |
---|---|
00 - 127 | Value |
Dimensions | 0.1600000x0.1000000x0.0450000 mm |
Hardware Platform | ZM3102 |
IP Class | IP 20 |
Device Type | Routing Multilevel Sensor |
Generic Device Class | Multilevel Sensor |
Specific Device Class | Routing Multilevel Sensor |
Firmware Version | 01.04 |
Z-Wave Version | 02.4e |
Certification ID | ZC08-09080006 |
Z-Wave Product Id | 0081.00a0.0001 |
Frequency | Europe - 868,4 Mhz |
Maximum transmission power | 5 mW |